Winter is coming and the temperatures are dropping. In some areas there will be sub-zero temps. Does this mean that your epoxy resin projects will have to wait until Spring? Maybe, but most of the time that is not the case. You can still have a successful project, with a little extra planning and following […]
Applying a seal coat to a table top or bar top is a simple procedure. Step 1 – Mix up a small quantity of ProGlas 1000 Epoxy resin. (1 Gallon will cover 48 sqft seal coat.) Step 2 – Pour epoxy onto surface. Step 3 – Spread with a foam brush, or foam roller, or […]
When using ProGlas 1000, most of the time, a seal coat will be needed. A seal coat will seal in the air pockets that exist in the substrate. The reason this is necessary is that when you apply a flood coat, the heat generated by the epoxy resin will cause the air in the pores […]
Another great customer of ours, Tommy, recently repaired his paddleboard with our epoxy resin, pigments and fiberglass. First, Tommy needed to repair a fin on the board. He used our Proglas Epoxy with the 2:1 Hardener. He added milled glass fibers to make a strong paste to hold the fin tight. He then covered the […]
Boat Deck Repair Charles in Dallas repaired his boat deck using Fiberglass Warehouse products. The old deck had rotted out and need to be replaced. First he tore out the old plywood deck. He checked the stringer to make sure they were still good. He install a new plywood deck. And covered it with knitted […]
Randy from Manitoba needed to re-do his RV’s roof. The roof has seen better days. First he added a layer of plywood to the existing roof and then fiberglassed over top of it to make it waterproof. Here is a list of materials he purchased: Pro Glas 1200 Epoxy Resin UV Enhanced- Part A – […]
This tutorial is for using Fiber Foam II. Fiber Foam II is a 2 part polyurethane foam. When mixed together, will expand to a 2 lb density foam. Preparation: Area to be foamed must be dry. Be sure to have escape for foam, we suggest a minimum of 1.5″ to 2″ hole. The foam […]
A customer of ours makes 1/5 scale RC Mustang P-51 airplanes that travel at an excess of 100 mph. He uses our cloth in the building of the planes. In particular our Style #3733 5.6 oz x 50″ and our Style #1522 4 oz x 50″.
First time users of gel coat can come across many problems with applying the gel coat. We will be doing a series of posts that describe the different issues and remedies for the various issues.